Microbial Root Zone Conditioner

Application Instructions:

Application rates are shown on the picture gallery chart for common pests (see images).

Preventative dosage rate:

Add 1ml to 2 litres of nutrient solution on a weekly basis or whenever solutions are replaced. Apply this rate for any additional water added to the tank after initial dose. Continued use of Microbial as a maintenance measure will assist the plant to keep most problems from developing in all stages of its growth.

Microbial Maintenance dosage rate:

For intense dosing of substrate systems to offset rootzone problems, total saturation of the substrate weekly with a pre dosed tank mix of 2mls per litre would be advisable.

One application should be sufficient but daily dosing would be advisable. Continued treatment is advisable until an improvement in plant health has been observed. For recirculating systems like nutrient film technique or aeroponics, dose nutrient tank at 2mls per litre for every litre of water that goes into the tank.

Points to be aware of when using Microbial

Microbial is a great solution additive to improve the overall health of plants. Healthy plants are better equipped to discourage pest and fungal outbreaks as well as other bacterial pathogens. Be aware Microbial does not promote beneficial bacterial growth. If you are trying to promote beneficial bacteria growth this is probably not a desirable solution to use.

When dosing tanks with Microbial it may cause the solution to foam up initially. This foaming will dissipate over time and will not have any adverse effect on plants. Be sure to turn off all forms of oxygenation methods while dosing tanks.

Note: Not suitable for Aquaponics and organic systems